|
| ||||||||||||||||||||||||||||||||||||
|
|
Carpet Tile Installation
Carpet Tile installation can easily be performed by a novice. You simply need basic
The first step in installing carpet tile is to establish whether the room is "square". A trapezoidal or parallelogram-shaped room will present no problems (until you get to the walls). A room that is off-square may provide a tile pattern like this:
To begin:
In laying out your tile, you may choose to quarter turn tiles. Most carpet tiles have arrows on the back of each tile indicating the manufactured pile direction. By quarter turning tiles, you change the shading of tiles to create a checkerboard effect utilizing the lighting reflectance differences caused by pile direction. Click on the links
below to learn more about carpet.
Need content? You may use any article in this site at your website, or in your newsletter. The only requirement is inclusion of the following sentence and link: "Article by Michael Hilton of carpetbuyershandbook.com - the Largest Online Source for Unbiased Carpet Information (http://carpetbuyershandbook.com)" .
|
| ||||||||||||||||||
along the room walls unless you plan how the installation will finish up.
points along the line. Confirm that the measurements are similar. It is not uncommon for the measurements to vary by 1-2 inches, but if the measurements vary by 4-6 inches or more, you may want to measure your walls, again, and snap a new line.
nter point to each room corner to confirm that the measurements are similar. This will confirm the proper starting point for your tile installation.
s. Make sure the tile is located evenly on both lines. A minor variance will multiply significantly as you move outward toward the wall.
tightly until you come to a point where a full tile cannot be placed between the last tile and the wall. If the last tile fits evenly, call the Pope, because another minor miracle has occurred. If you want a homogeneous installation, make sure the carpet pile direction is pointed in the same direction. Many carpet tiles use arrows to indicate the manufactured direction. Turning the tiles will create a 
drant at a time), making sure that tiles are placed evenly with the butting tiles. Note (as in the installation) that the tiles may not be perfectly in line when your reach the edge. Patterned goods will telescope these differences, solid color tiles will hide these differences. Since carpet tile is a seamless installation, you may choose to adjust tiles as you work (allowing more or less gap at the tile edges to ensure a consistent finish).
