|
| ||||||||||||||||||||||||||||||||||||
|
|
Did you know? Dry foam extraction carpet cleaning is the second driest carpet cleaning method and scientific studies show it is very effective in removing dust mite allergen, mold allergen, and
carpet cleaning results are excellent.
Dry Foam Carpet Cleaning MethodThe dry foam method is an effective low moisture, rapid drying carpet cleaning method that has been used in carpet cleaning for decades. The dry foam method is similar to the rotary shampoo method in that brushes are used to agitate the carpet pile. In the dry foam method, an aerator is used to whip the solution in a foam. The foam is dispensed into the horizontally rotating brushes. As with all carpet cleaning methods, the more chemical that is applied, the longer the drying time. Some machines have their own extraction capability. These machines have the capability to remove shampoo and attached soil particles. Other machines do not have extraction capability. A wet/dry vacuum must be used to remove the shampoo and soil. The solution used for this method should contain a quality surfactant, an alkaline builder to soften water, and a dry solvent to assist in emulsification of oils. A defoamer is normally used to eliminate foaming in the vacuum recovery tank. Application The following steps should be followed for use of the dry foam carpet cleaning method: 1. Vacuum the area to be cleaned thoroughly, using good vacuuming techniques. 2. Apply a quality preconditioner and allow ten to twenty minutes dwell time. A heavier application of preconditioner should be applied to more heavily soiled areas.
4. Allow the machine to generate an appreciable amount of foam before beginning carpet cleaning procedures. 5. Push the machine, walking at a slow deliberate pace for about twenty feet. If you are moving too slowly, excess foam will appear at the edges of the brushes. If you are moving too quickly, streaks will appear on the carpet pile. 6. At the end of the twenty foot pass, (on most loop pile carpets) turn the machine and walk (pushing the machine) in the opposite direction (lawn mover style) with a two to four inch overlap of the previous lap.
7. On directional carpets such as most cut piles, turn the machine off and return to the starting point. Leave a two to four inch overlap and repeat procedures.
While some dry foam-in-a-can products are sold at large discount stores, their use should be discouraged. Their carpet cleaning results are marginal, but resoil potential can be heavy.
The link below has been carefully optimized to generate traffic for every page on your site, where our link is displayed, and to generate visitors to our site. Use this link exactly as it is displayed to ensure high search engine ranking results generation to your site.
To place our optimized link on your site
Need content? You may use any article in this site at your website, or in your newsletter. The only requirement is inclusion of the following sentence and link: "Article by Michael Hilton of carpetbuyershandbook.com - the Largest Online Source for Unbiased Carpet Information (http://carpetbuyershandbook.com)" .
|
| |||||||||||||||||
